To set the three levels of alarm: . . . . . . . . . . . . . . .3-7
Setting the Three Ultima X Series
Gas Monitor Alarm Setpoint Values . . . . . . . . . . . . .3-8
To set the three levels of alarm: . . . . . . . . . . . . . . .3-8
Enabling/Disabling and Setting
the Mode of the Three Ultima Alarm Setpoints . . . .3-9
Enabling/Disabling and setting the Mode
of theThree Ultima X Series Alarm Setpoints . . . .3-10
Procedure 6. Setting the Current Time . . . . . . . . . . .3-11
To update the Ultima Gas Monitor internal clock: .3-11
Procedure 7. Setting the Current Date . . . . . . . . . . .3-11
To update the Ultima Gas Monitor internal date: . .3-12
Procedure 8.
Enabling/Disabling Ultima Gas Monitor
Calibration Output Signal . . . . . . . . . . . . . . . . . . . . . .3-12
To enable or disable the calibration output signal: 3-12
Procedure 9.
Setting the Number of Days Between
Ultima Gas Monitor Auto-calibration Periods . . . . . . .3-13
Setting Time that Ultima Gas Monitor
Auto-calibration is to begin: . . . . . . . . . . . . . . . . . .3-13
Procedure 10.
Setting the Date of the Next Scheduled
Ultima Gas Monitor Calibration . . . . . . . . . . . . . . . . .3-14
Procedure 11. Changing the MUX Address . . . . . . . .3-14
To Change the Address . . . . . . . . . . . . . . . . . . . . .3-15
Procedure 12.
Viewing the Previous Successful Calibration Date . .3-15
Procedure 13.
Calibrating/Checking
the 4-20 mA Ultima X Series Outputs . . . . . . . . . . . .3-15
Procedure 14. Resetting Ultima X Series Monitors . .3-16
Procedure 15. Setting the Alert Option
on an Ultima X Series Sensor . . . . . . . . . . . . . . . . . .3-17
Table 3-2. Alert Operation Settings . . . . . . . . . . .3-17
Procedure 16.
Setting the Sensor Swap Delay
on an Ultima X Sensor . . . . . . . . . . . . . . . . . . . . . . . .3-17
iii