EC Declaration of ConformityMSA
ULTIMA X
®
Series
GB
3
EC Declaration of Conformity
Manufactured by: Mine Safety Appliances Company
1000 Cranberry Woods Drive
Cranberry Township, PA 16066 USA
The manufacturer or the European Authorized Representative:
MSA AUER GmbH, Thiemannstrasse 1, D-12059 Berlin
declares that the
product
ULTIMA XE Main
ULTIMA XE Main with HART Module
based on the EC-Type Examination Certificate: DMT 02 ATEX E 202 X
complies with the ATEX directive 94/9/EC, Annex III. Quality Assurance Notification
complying with Annex IV of the ATEX Directive 94/9/EC has been issued by
Ineris of France, Notified Body number: 0080.
The product is in conformance with the EMC directive 2004 / 108/ EC,
EN 50270 :2006 Type 2 *, EN 61000 - 6 - 4 : 2007
* EN 61000-4-6 : Ultima XE MAIN HART MODULE : occasional transmission error can appear at the
2-wire version. A fault check has to be used at the receiver unit.
The product complies with the directive 96/98 / EC (MarED),
based on the EC-Type Examination Certificate :
SEE BG 213.038
The quality survaillance is under the control of SEE BG, Notified Body number: 0736
We further declare that the product complies with the provisions of
LVD Directive 2006 / 95/ EC, with the following harmonised standard:
EN 61010-1 :2002
MSA AUER GmbH
Dr. Axel Schubert
R&D Instruments
Berlin, October 2008
To Next Page
Loading...
