NS50 wireless network switch
User Manual
Revision C
Chapter 5: Configuration Using the Web Interface
The IP address of the default gateway.
The DNS server to be used when looking up host names.
The backup DNS server to be used when looking up host names.
Configuration Management
These settings are only required for 3rd party TFTP servers or ICA v1.3.1 and earlier.
0: Disabled
1: Enabled - device will check the TFTP server for changes at startup
and every "tftp.self_check_interval" minutes
The number of seconds elapsed before checking for new TFTP
settings. If zero, do not perform regular checks.
The TFTP server address to use. If blank, and in DHCP mode, use
the address supplied by DHCP.
System
Network names, contact details and passwords can be edited in the system section of the configuration
file as shown below.
Contact name for the network devices.
Location of the network devices.
Administrator password. The default password is "admin".
User password. The default password is "user".
Device hostname as displayed in the Device Scanner, should be
unique for each device.