NS50 wireless network switch
User Manual
Revision C
Chapter 5: Configuration Using the Web Interface
The SNMP community string for reads. Unless otherwise
necessary, this is usually left as public.
The hostname or IP address of the primary SNMP trap.
The hostname or IP address of the secondary SNMP trap.
Asset Tracking and Location Servers
This section configures asset tracking and location servers, consisting of AeroScout Positioning Engines
or MST Tracker Engines. This is where AeroScout tag and Wi-Fi client device information is sent.
Configuration is not required when communicating with an AeroScout positioning engine.
tracking.aeroscout.enabled
Tracking of AeroScout tags.
0: Disabled
1: Enabled
tracking.aeroscout.rogue_ap_dete
ction
Reports non-compatible access points on the network to the
AeroScout Engine.
0: Disabled
1: Enabled
tracking.aeroscout.excited_tags_
only
Only sends tracking information for detected tags within range of
an exciter.
0: Disabled
1: Enabled
tracking.rssi_threshold.tag
By default it is set at -95. Only tag reports higher than this signal
strength threshold will be sent to the positioning engines.
tracking.rssi_threshold.mu
By default it is set at -95. The default value should not be
changed without understanding the implications. Only Wi-Fi
client frames higher than this signal strength threshold will be
sent to the positioning engines.
These settings configure up to two MST Tracker Engines that the access point will send information to.
The "x" in each parameter is replaced by the tracking engine number.