NS50 wireless network switch
User Manual
Revision C
Chapter 5: Configuration Using the Web Interface
tracking.tracker.x.enabled
tracking.tracker.x.excited_tags_only
Only sends tracking information for detected tags within
range of an exciter.
0: Disabled
1: Enabled
tracking.tracker.x.server_address
The IP address of the MST Tracking Engine.
tracking.tracker.x.server_port
UDP port to be used by messages sent to the MST Tracker
Engine. Default 1142.
tracking.tracker.x.status_reporting_interval
The period in seconds between status reports being sent to
the MST Tracker Engine. These status reports are used to
determine Access point availability.
VLAN Configuration
The VLANs section defines VLANs for the devices as shown below. For large networks it is recommended
that VLAN settings are applied to all network devices consistently by using centralised configuration
management. Up to 8 VLANs can be defined, the "x" in each address is replaced by the VLAN number
1-8. By default, the site configuration file has some VLANs predefined based on commonly used
applications. VLAN parameters are described in the table below.
The VLAN ID that will be tagged to frames sent to trunk ports
from VLAN x.
Priority from 0-7 (with 7 being the highest) that is assigned to
frames on VLAN x.
The administrative name for VLAN x.
NOTE: The Infrastructure VLAN cannot be edited or disabled because the management
CPU is on this VLAN.
To Next Page
Loading...
Need help?
General
