NS50 wireless network switch
User Manual
Revision C
Chapter 5: Configuration Using the Web Interface
The following settings configure options specific to WEP or WPA security; only the options specific to the
chosen security mode need be configured.
wireless.radio.1.ap.x.wep.auth
wireless.radio.1.ap.x.wep.keylen
The WEP key length,
longer is more secure
0: Short Key (64 bit)
1: Long Key (128 bit)
wireless.radio.1.ap.x.wep.use_key
1-4 Determines which of the
following preconfigured keys to use
wireless.radio.1.ap.x.wep.key.1
wireless.radio.1.ap.x.wep.key.2
wireless.radio.1.ap.x.wep.key.3
wireless.radio.1.ap.x.wep.key.4
wireless.radio.1.ap.x.wpa.mode
1: WPA
2: WPA/WPA2
3: WPA2 Only (recommended)
wireless.radio.1.ap.x.wpa.cipher
1: TKIP
2: AES
3: TKIP/AES
wireless.radio.1.ap.x.wpa.rekey_time
The WPA group rekey
interval
wireless.radio.1.ap.x.wpa.psk
The Pre-Shared Key for
WPA-Personal mode
Wireless EAP Configuration
The Wireless EAP section is used to configure the RADIUS server as shown below. This is applicable
for wireless networks configured with WPA Enterprise security mode. A primary and secondary (backup)
RADIUS server can be set up and configured. A description of the editable parameters are shown in the
following table. The "x" in each parameter below should be replaced with "primary" or "secondary".