EasyManuals Logo

MST Impact NS5004 User Manual

MST Impact NS5004
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
NS50 wireless network switch
User Manual
Revision C
Chapter 5: Configuration Using the Web Interface
© 2012 MST Global
Commercial in Confidence
57
NOTE:
WAC 1 must be upgraded before WAC 2. Complete steps 1-4 for for every WAC on
the network
that you are upgrading, then move onto step 5.
Firmware upgrades may reset the network device to default factory settings
(please refer to the firmware release notes to determine if this will occur).
It is STRONGLY recommended to install ICA 1.4.1 (or greater) at the site and use
the central configuration management capability to re-apply device settings. See
Device Management Overview on page 83 for more detailed instructions.
For devices that are not managed by the ICA, configuration settings can be saved
before updating firmware and restored after the update from the TOOLS > ADMIN
screen. For more information, see Saving and Restoring Configuration Settings on
page 52.
NOTE: Before starting this procedure, note the following
The device's MAC address (visible in STATUS > DEVICE INFO)
Settings on the device that differ from the Site Defaults

Table of Contents

Other manuals for MST Impact NS5004

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MST Impact NS5004 and is the answer not in the manual?

MST Impact NS5004 Specifications

General IconGeneral
BrandMST
ModelImpact NS5004
CategorySwitch
LanguageEnglish

Related product manuals