NS50 wireless network switch
User Manual
Revision C
Chapter 5: Configuration Using the Web Interface
Centralised configuration checklist
Confirm all required template settings in the Configuration > AP Config Templates editor.
In Devices > Access Points , select the device, tick the Manage Configuration checkbox and
select the correct template.
If required, click Edit Overridden Parameters and edit any required parameters for the specific
device.
Save the new settings.
settings.
Wait for the device's Managed status to change from PENDING to CURRENT.
NOTE: As a template can be applied to multiple devices, it is fixed to DHCP for
networking to avoid address conflicts. If static IP addresses are required, these must
be set in the individual devices' overridden parameters.
It is recommended that a client device (PC or laptop) has a wired connection to the network device to
upgrade the firmware. Please contact your MST System Engineer for firmware files.
To upgrade the firmware:
1. Click Choose File. A dialog box will open.
2. Select the binary (.bin) firmware file and click Open.