6
Connecting and configuring external devices
Crop protection sensors
1. Connect the sensor to the ISOBUS.
2. Follow the instructions from the sensor manufacturer. The terminal does not need to be
configured.
To work with serial connection sensors:
1. Connect the sensor to the serial port of the terminal.
2. Create a virtual job computer in the Virtual ECU app. [➙ 61]
3. In the “External controller” [➙ 62] parameter, select the sensor type.
4. Activate the job computer for the sensor.
⇨ You have activated the sensor.
⇨ The terminal transmits all target rates to ISOBUS-TC, the ISOBUS job computer and TRACK-
Leader.
Special case
If you are working with your machine in mixed operation, with ISOBUS and serially connected
sensors, you must observe the following sequence:
The serial sensor is connected to the serial interface of the terminal.
1. Connect the ISOBUS components to the ISOBUS.
2. Start the Virtual ECU [➙ 61] app.
3. Create a virtual job computer in the Virtual ECU app. [➙ 61]
4. In the “External controller” [➙ 62] parameter, select the sensor type.
5. Activate the job computer for the sensor.
⇨ You have activated the sensor.
6. Set the connectors in the list of connections.
⇨ The terminal transmits all target rates to ISOBUS-TC, the ISOBUS job computer and TRACK-
Leader.
To Next Page
Loading...