Muller TOUCH800 - Troubleshooting; General Errors; GPS Errors

13
Troubleshooting
84
V9.20191001
30322538-02-EN
Troubleshooting
The following error messages can appear during operation, amongst others:
General
Error message text
Possible cause
Possible error correction
Some files could not be deleted. The files that should be deleted are
currently being used.
Object pool error Delete the object pool and restart the
terminal. [
➙
49]
ECU: Offline - The connection has been
broken.
The connections between the terminal and
ECU have been broken.
Check the connection. [➙ 17]
GPS
Error message text
Possible cause
Possible error correction
GPS receiver reset failed.
The wrong driver was selected.
Select the correct driver. [
➙
28]
The external lightbar is activated.
Deactivate the external lightbar [➙ 40]
and connect the
GPS receiver directly to
the terminal. [
➙
28]
The GPS receiver is not enabled for E-Dif. There is no E-Dif activation on the GPS
receiver.
Please contact technical support.
GPS receiver has been removed. The connection between the terminal and
GPS receiver has been broken.
Check the connection. [➙ 28]
The GPS receiver has been configured for
TRACK-Leader AUTO.
Reset the baud rate for the GPS receiver.
[
➙
30]
GPS receiver not initialized. The terminal does not recognise the
configuration of the GPS receiver.
Reset the GPS receiver to its factory
settings. [
➙
30]
Timeout.
The wrong driver was selected.
Select the correct driver. [
➙
28]
The external lightbar is activated.
Deactivate the external lightbar [➙ 40]
and connect the
GPS receiver directly to
the terminal. [
➙
28]
SIM card is not unlocked. The PIN request for the SIM card is
activated.
Deactivate the PIN request for the SIM
card.
Invalid entry. Unauthorised special characters were
used in the entry.
Correct the entry.
The connected receiver could not be
recognized.
The wrong driver was selected.
Select the correct driver. [
➙
28]
An unknown GPS receiver has been
connected.
Use the default GPS driver. [➙ 28]
13