Muller TOUCH800 - Tractor-ECU Errors; Virtual ECU Errors

Troubleshooting
13
30322538-02-EN
V9.20191001
85
Error message text
Possible cause
Possible error correction
The modem is not answering. The connection between the GPS receiver
and GSM modem has been broken.
Check the connection.
The modem is not ready for
communication yet.
Please wait for a moment.
Restart the system.
The driver cannot read.
The external lightbar is activated.
Deactivate the external lightbar [➙ 40]
and connect the
GPS receiver directly to
the terminal. [
➙
28]
The driver cannot write.
Tractor-ECU
Error message text
Possible cause
Possible error correction
A vehicle must be activated!
There is currently no activated vehicle.
Activate a vehicle. [
➙
51]
Active tractor geometry may be
incomplete. Check settings.
Check the tractor geometry. [➙ 56]
Virtual ECU
Error message text
Possible cause
Possible error correction
Caution! The geometry settings for the
machine have been reset.
The geometry of the virtual ECU is faulty. Check the geometry of the virtual ECU. [
➙
63]
The connection to the external controller
has been interrupted.
The connection between the terminal and
the external on-board integrated
display/controller has been broken.
Check the connection. [➙ 41]
Error! There is no active machine.
There is currently no activated machine.
Activate a machine. [
➙
61]
This profile name already exists! Abort
entry?
The identical profile name has already
been used.
Enter a different profile name. [➙ 62]
Working width or sections have not been
entered or are invalid. Abort entry?
The entries for the working width and
sections are incomplete.
Check the settings for the working width
and the sections. [
➙
63]