MULTISOFT DGR-1000 - Page 71

Video Grabber DGR-1000 User Manual - v. 1.4 (FW 1.9)
71
LAN Bridging
OBJECTNUMBER
Name
Access
Type
Description
9
lanBridging
read-write
Enum
Create network bridge between
LAN 1 and LAN 2.
0 – disabled
1 – enabled
10
lanBridging
Lan1Termination
read-write
Enum
Anti-loop termination for LAN 1
interface. To be used on the first
grabber in the chain only.
0 – disabled
1 – enabled
11
lanBridging
Lan2Termination
read-write
Enum
Anti-loop termination for LAN 2
interface. To be used on the first
grabber in the chain only.
0 – disabled
1 – enabled
Example:
To reconfigure Video Grabber with IP address 192.168.5.2 on LAN1 interface to 172.16.5.2/8 one
would have to run the following commands:
First change the IP address of LAN1 to 172.16.5.2:
snmpset –v3 –l authPriv –u rw_user
-a MD5 –A uXTxzFQOscIZR1qcMAOSEwxf2HDeD6
-x DES –X LlUzFSpOVmBrem3VOFYfqd42VB1vve
192.168.5.2 1.3.6.1.4.1.46236.1.3.5.2.0 s “172.16.5.2”
Then change the netmask on LAN1 interface to 255.0.0.0:
snmpset –v3 –l authPriv –u rw_user
-a MD5 –A uXTxzFQOscIZR1qcMAOSEwxf2HDeD6
-x DES –X LlUzFSpOVmBrem3VOFYfqd42VB1vve
192.168.5.2 1.3.6.1.4.1.46236.1.3.5.3.0 s “255.0.0.0”
Then apply the settings:
snmpset –v3 –l authPriv –u rw_user
-a MD5 –A uXTxzFQOscIZR1qcMAOSEwxf2HDeD6
-x DES –X LlUzFSpOVmBrem3VOFYfqd42VB1vve
192.168.5.2 1.3.6.1.4.1.46236.1.3.11.1.0 i 4321