MULTISOFT VGR-1000 - Confcontrol (Subsection 4)

Video Grabber User Manual - v. 1.19 (FW 1.29)
56
5.5.4. confControl (subsection 4)
In the following tables only OBJECTNUMBER part of the identifier (OID) is listed.
OBJECTNUMBER
Name
Access
Type
Description
1
monitorEmulation
read-write
enum
Enable monitor emulation
0 – NONE – emulation disabled
1 – VGA – analog VGA monitor
emulation
2 – DVI – digital DVI monitor
emulation
3 – DP – digital DisplayPort
monitor emulation (supported
only by Video GrabberDP)
2
displayNtpInfo
read-write
enum
Show NTP info on the Video
Grabbers OLED screen
0 – disabled
1 – enabled
Example:
To show NTP info on the Video Grabber’s OLED, given that Video Grabber’s IP address is 192.168.5.2
one would have to run the following commands:
First set the displayNtpInfo object to enabled (1):
snmpset –v3 –l authPriv –u rw_user
-a MD5 –A uXTxzFQOscIZR1qcMAOSEwxf2HDeD6
-x DES –X LlUzFSpOVmBrem3VOFYfqd42VB1vve
192.168.5.2 1.3.6.1.4.1.46236.1.3.4.2.0 i 1
Then apply the settings:
snmpset –v3 –l authPriv –u rw_user
-a MD5 –A uXTxzFQOscIZR1qcMAOSEwxf2HDeD6
-x DES –X LlUzFSpOVmBrem3VOFYfqd42VB1vve
192.168.5.2 1.3.6.1.4.1.46236.1.3.11.1.0 i 4321