© Munters AB, 2020 23
5
Feed Management
•
Feeding Summary
•
Setting up Feeding
5.1
Feeding Summary
Feed is stored in silos located outside the animal house. Augers transport the feed to hoppers. Sensors
are installed on the augers and hoppers to ensure that the proper amount of feed is transported. Feed
lines transport the feed from the hoppers to feeding pans, according to signals sent from the hoppers. Trio
receives inputs from the augers and hoppers that enable controlling the feed distribution (start and stop
signals). In addition, the user enable am alarm if the run time exceeds the defined parameters.
A feeder relay must be wired, defined, and mapped.
Feed line and feeder active digital sensors must be wired, defined, and mapped.
5.2
Setting up Feeding
Use the Feed Screen to turn on/off augers and feeders according to the user-designed schedule. All
augers operate according to the auger schedule and all feeders work according to the feeder schedule.
1. Go to Control > Feeding.
2. Click .
To Next Page
Loading...
Need help?
General
