Print Media 4-5
Layered
Adhesive
Folded, creased, curled, embossed, warped, or wrinkled
Perforated, three-hole punched, or torn
Too slick, too coarse, or too textured
Different in texture (roughness) on the front and back
Too thin or too thick
Stuck together with static electricity
Composed of foil or gilt; too luminous
Heat sensitive or cannot withstand the fusing temperature (180°C
[356°F])
Irregularly shaped (not rectangular or not cut at right angles)
Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
Acidic
Any other media that is not approved
Thick Stock
Paper thicker than 90 g/m
2
(24 lb bond) is referred to as thick stock.
You can print continuously with thick stock. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Capacity Tray 1/2 Up to 20 sheets, depending on their thick-
ness
Tray 3/4 Not supported
Orientation Tray 1 Face down
Tray 2 Face up
Driver
Media Type
Thick 1 (91–150 g/m²)
Thick 2 (151–210 g/m²)
Weight 91 to 210 g/m²
Duplexing Refer to “Specifications” on page 4-2.
To Next Page
Loading...
Need help?
General
