Registering a user15-4
Registering a user using Data Administrator
To use Data Administrator, configure this machine, and set up Data Admin-
istrator. For setup, install the IC Card Driver (USB-Driver) of the authentica-
tion unit, and then install Data Administrator IC Card Plugin.
" Before setup, install Data Administrator V4.0 or later in your com-
puter. For the Data Administrator operating environment and installa-
tion procedure, refer to the Data Administrator User's Guide.
Checking the version of the installed Data Administrator
1 From the [Help] menu of Data Administrator, select [Version Informa-
tion].
" This software cannot be used if the version is "3.x". Install "4.x".
If Data Administrator V3.x is installed, it is removed when V4.x is
installed.
2 Click [Plug-in version].
3 In [Plug-in information list], confirm the plugin version of Data Adminis-
trator.
– This software is available if the plugin version is "4.x".
To Next Page
Loading...
