Using a Web Service9-12
Using a Web Service
The scan command can be sent from a computer (Windows Server 2008 R2/
7/Vista/Server 2008) on the network or this machine can scan using a speci-
fied operation, and the scan data can be sent to a computer. The settings that
must be specified in advance on the computer are described below.
Settings required to use a Web Service
The following settings are required in order to use a Web Service.
Install this machine on the computer.
Specify settings on the machine for using a Web Service.
" Specify the Web Service settings on the machine from the Admin Set-
tings screen. For details, refer to the [Reference Guide].
Installing this machine on the computer
Confirmation before installation
Before installation, make sure that “Network Discovery” (Network and Shar-
ing Center in Control Panel) is enabled.
Installation procedure
1 In the Start button menu, click “Network”.
The devices connected to the network appear.
2 Right-click the scanner icon for this machine, and then click “Install”.
– Depending on the settings specified on the computer, a UAC (User
Account Control) message may appear. Check the information
described in the message, and then continue with the procedure.
– If both scanning and printing using a Web Service have been enabled
on this machine, this machine appears as a printer icon.
– The driver software is automatically installed. After a confirmation
message appears, click [Close].
3 From the control panel of the machine, select “Web Service”, and then
check that a destination appears.
To Next Page
Loading...
Need help?
General
