Muratec MFX-C3035 - Using authentication device (IC card type); Configuring this machine

Using authentication device (IC card type)15-2
Using authentication device (IC card type)
The authentication device (IC card type) is an IC card authentication system
that reads the IC card to perform personal authentication. Using this system,
you can perform authentication with an IC card to log in to this machine or
execute a print job when User Authentication is enabled in this machine.
To use the authentication device, first register the card ID of the user in this
machine. The registered user, who is authenticated with the card ID, can log
in to this machine or execute a print job. This section explains how to config-
ure the required settings in this machine, register users, and log in to this
machine with authentication.
" Do not disconnect the USB cable while using the authentication
device. Doing so may cause the system to become unstable.
" Do not leave the IC card within 40 mm of the card reader.
Configuring this machine
User authentication settings must be configured with MFP authentication on
this machine.
Configure the user authentication settings using Web Connection.
" For details on using Web Connection, refer to "Reference Guide".
1 In Administrator mode of Web Connection, click [Security] tab - [Authenti-
cation] - [General Settings].
2 In [User Authentication], select [Device].