Specifying destinations10-16
2 Select the destination from the list, and then press the [Start] key.
" Only one destination can be selected from the log.
" The only destinations that appear in the log are those specified after
pressing [Direct Input].
In addition, destinations specified with broadcast transmissions do not
appear in the log.
Selecting a program destination
Data can be sent with a program destination previously registered on the
machine.
Program destinations are registered with destinations where data is fre-
quently sent together with scan settings allowing data to easily be sent with-
out the trouble of specifying the various settings.
" In order to select a program destination, the program destination must
first be registered on the machine. For details, refer to “Registering a
program destination” on page 10-36.
1 Press [Scan to E-mail] to display the initial Scan to E-mail mode screen.
– For details on the initial Fax screen, refer to “Initial Scan to E-mail
mode screen” on page 2-9.
2 Position the document to be scanned.
– For details on loading the original document, refer to “Loading a Docu-
ment” on page 4-36.
3 Press the [Mode Memory] key.
4 Select the desired program destination from the list, and then press [OK].
The settings and destination addresses are recalled.
" Only one program destination can be selected.
5 Press the [Start] key.
– Press the [Start (Color)] key to scan in color, or press the [Start (B&W)]
key to scan in black and white.
To Next Page
Loading...
Need help?
General
