Logging in to this machine15-16
Associating the user with card using authentication
device
When a user and card ID have been registered using Data Administrator, the
user must be associated with the card in the Administrator Settings of the
machine.
1 Press [Utility/Counter] key on the control panel of this machine to switch
to the [Admin Settings] screen.
2 Press [Authentication Setting].
3 Press [Card Authentication].
4 Select a user to be registered, and press [OK].
– Press [All] to display all users. Press [Search] to extract target users
with search characters.
5 Press [Edit].
– Press [Delete] to cancel the registration when IC card information is
already registered.
6 Place the IC card on the authentication device, and press [OK].
– This associates the user with the IC card and registers the IC card for
the user.
Logging in to this machine
The following explains how to log in to this machine with IC card authentica-
tion.
îš„ To perform IC card authentication, register the information recorded in the
IC card in advance.
îš„ If an authentication failure recurs, the problem may be due to incorrect
registration of IC card information. Register IC card information again.
îš„ When [Card Authentication] is specified for [Authentication Type], a regis-
tered user is authenticated by simply placing the IC card. When [Card
Authentication + Password] is specified, a registered user is authenticated
by placing the IC card and entering the password.
îš„ Press [User Name] and [Password] to log in by entering the user name
and the password, without using the authentication device.
To Next Page
Loading...
Need help?
General
