Registering a user 15-15
10 Click [Write].
– Data Administrator provides the batch copy function that batch-con-
figures the registered user data in multiple machines with the authenti-
cation device enabled.
The registered user data is configured in this machine.
11 Click [OK].
12 If the authentication device is already connected to the computer, remove
it, turn the main power of this machine off, and then connect the authenti-
cation device to this machine.
" To turn the power switch of this machine off and on, first turn the main
power switch off, and then turn it on after 10 or more seconds has
elapsed. Not doing so may result in an operation failure.
" When connecting or disconnecting the USB cable, hold the plug. Oth-
erwise, the cable may be damaged.
If you only enter the card ID when registering a user, associate the user with
card using the authentication device connected to this machine.
To Next Page
Loading...
