• When dedicated media is used, the setting of printing quality is set according to each media type.
For the settings, refer to
"7.1.2 Printing operation specifications".
Setup item Setting value Description
Effect <None> The Effect function is not used.
Wave The printing joint will be the wave form.
The print quality may improve compared to “None”.
Fog The printing joint will shade off.
Set up this menu when obvious white lines or uneven
print density appear on printed media in “Wave”.
This is a mode suitable for low resolution.
Fine&Fuzz The printing joint will shade off as the wave form.
Performs the printing at slower speed than “Wave”.
Fine&Fog The printing joint will shade off.
Set this when there is horizontal unevenness in
“Fine&Fuzz”.
Prints at a slower speed than “Fine&Fuzz”.
A-S. Fine&Wave Performs “Wave” printing using the half of the print
head nozzles.
Since only the half of the print head nozzles are used,
printing speed becomes a half of “Wave”.
Set up this menu to improve the print quality compared
with “Fine&Fuzz”. If used when one side of the nozzles
is clogged, quality deterioration may be avoided.
B-S. Fine&Wave Performs “Wave” printing using the half of the print
head nozzles on the opposite side of “A-
S.Fine&Wave”.
Since only half of the print head nozzles are used,
printing speed becomes a half of “Wave”.
Set up this menu to improve the print quality compared
with “Fine&Fuzz”. If used when one side of the nozzles
is clogged, quality deterioration may be avoided.
RollCut <On> Sets whether to cut the media after printing.
• ON: Automatically cuts the media after printing.
• OFF: The media is not cut after printing.
Off
CutMethod <2steps -Lo>*
1
Sets the media cut method when using the roll media.
• 2steps : Cuts the media twice.
• Hi/Lo : Changes the strength of cutting the media.
• 3steps : Cuts the media three times.
• Hi/Lo : Changes the strength of cutting the media.
*1:Default values differ depending on the media.
• Glossy paper : 2steps -Hi
• Other media : 2steps -Lo
<2steps -Hi>*
1
3steps -Lo
3steps -Hi
To Next Page
Loading...
Need help?
General