Troubleshooting RJ-900X series OPERATION MANUAL
6-14
6.2 Error messages
This section describes the messages displayed during the normal operation and occurrance of error of the
printer, and their solutions.
6.2.1 Status messages
This section describes the display during the printer operation.
When the product is operating correctly, the operation panel displays each operation status as below.
No. Possible cause Remedy Reference
1
Ready to Print Idling (Media is set). -
2
Paper End Idling (Media is not set).
3.4 Media
handling
3
Receiving Receiving data. (* displays a port no.) -
4
Converting Analyzing data. (* displays a port no.) -
5
Printing Under printing. -
6
Cleaning ** minutes Cleaning the head. Please wait a while.
5.2.3 Head
cleaning
7
Ink Refill **min Filling the ink. Please wait a while.
3.3 Installing
ink cartridges
8
Transport Mode Preparing for transportation. Please wait a
while.
5.3.2 Transpo
rting the printer
9
******** OK? Initializing the media.
Please wait a while.
(*** represents the setup media type.)
3.4.4 Releasin
g the Partial
Function of
Pressure Arms
10
Paper Initial
11
Cover Open The front cover is open.
3.4 Media
handling
12
Lever Up The media loading lever is lowered
backward. Set the media.
3.4 Media
handling
13
Layout Receiving After receiving print data, the printer is
waiting for the receive of the next data.
Displayed when the layout function is
enabled.
4.5.1 Setup
menu items
To Next Page
Loading...
Need help?
General