Before using RJ-900X series OPERATION MANUAL
3-2
3.1 Power cable connection
Power cable connection procedure is explained.
• Be sure to use the power cable supplied with the printer. If other power cables are used,
it would cause an electric shock or fire.
• Do not use damaged power cable. It could lead to an electric shock and fire.
• Pay attention to the following points, while handling power cable.
• Do not do anything forcefully on the power cable.
• Do not keep heavy objects on the power cable.
• Do not bend, twist or pull the power cable by force.
• Do not route the power cable near heating appliances.
• Contact MUTOH local dealer in case of power cable damage.
Install the ink cartridge as shown in the following procedure.
1.
Make sure that the printer power is turned OFF.
• Power is turned ON when the [Power] key of operation panel is pressed.
Press the key once again and turn OFF the power.
To Next Page
Loading...
Need help?
General