RJ-900X series OPERATION MANUAL Before using
3-3
2. Connect the power cable to the AC inlet on the back of the printer.
3. Power cable plug is correctly inserted in the socket.
• Do not take out or insert power plug with a wet hand. This could lead to an electric shock.
• Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V - 240
V). If the power supply other than the specified voltage is used, it could cause an electric
shock and fire.
• Take power for the printer directly from the power socket (AC 100 V - 120 V or AC 220 V
- 240 V). Do not use complex multiple plugs on the same socket. This could generate
heat and might cause fire.
• Make sure to use dedicated power socket with earth terminal for power supply, and
connect an earth terminal to it. If the earth wire is not connected, an electric shock or fire
may occur.
• Do not connect an earth wire to the following places.
• Gas pipe
There is a possibility of ignition and explosion.
• Earth wire of telephone cables and lightning rods
Heavy current might flow whenever a lightning strikes.
• Water pipe and faucet
The earth might not work if a plastic pipe is connected in the middle of the metal pipe.
No. Name
1
AC inlet
2
Power cable
To Next Page
Loading...
Need help?
General