Need help?Do you have a question about the MUTOH spitfire 90 and is the answer not in the manual?
Provides general safety guidelines for safe printer operation, covering placement and handling.
Details the handling, locations, and types of warning labels attached to the printer.
Explains how to navigate and operate the self-diagnosis mode.
Allows performing inspections on circuit boards, sensors, fans, and checking history/signals.
Provides functions for aligning printing position and correcting media feed operation.
Enables modification of various adjustment parameters, including initialization and updates.
Explains how to start up and operate the maintenance mode.
Includes functions for counter display, initialization, and MAC address writing.
Initializes life counters, including print count, ink capacity, and motor service life.
Lists adjustments needed after replacing parts, referencing auto-diagnostic functions.
Explains parameter backup methods and types.
Outlines steps to record backup parameters from Mainboard onto a memory card.
Explains installing backup parameters from a memory card into a new Mainboard.
Explains procedures for installing firmware programs that control printer operation.
Explains the procedure for adjusting the tension of the steel belt.
Details the procedure for adjusting the tension of the PF deceleration belt.
Explains adjusting head angle and forward/rear position.
Provides steps to adjust the head forward/rear position.
Performs adjustments to align even rows based on odd row references.
Performs adjustments to correct gaps between heads in uni-directional printing.
Explains messages, check points, and remedies for errors indicated by messages.
Addresses issues that occur without displayed error messages, like power loss or paper feed problems.
To Next Page
General