Spitfire – Maintenance Manual
173
AP-74096, Rev. 1.0, 09/06/05
5.5.12. Software Counter Initialization Menu
This menu initializes the software counters such as the ink amount counter.
Notes :
¾ Before delivery, always initialize the software counters.
The software counters that can be initialized through this menu are as follows.
Counter Initial value
Ink amount counter 0
Ink consumption counter 1 0
Ink consumption counter 2 0
Ink consumption counter 3 0
Ink consumption counter 4 0
Ink consumption counter 5 0
Ink consumption counter 6 0
Ink consumption counter 7 0
Ink consumption counter 8 0
Cumulative printout timer 0
Waste ink counter 0
Ink ID mask Reset
Initial ink charge flag Set
Pressing the [ENTER] key in the operation panel performs the software counter initialization. Pressing the
[CANCEL] key cancels the initialization.
* CountClear *
Counter reset ?
↓ ENTER
* CountClear *
Wait little time
↓ End initialization
* CountClear *
R. Sns. Pos. Testprint
CleanHead CountClear
(3/4)
To Next Page
Loading...
