Handling the printer RJ-900X series OPERATION MANUAL
4-26
c. Press the [Enter] key on Operation panel.
• “Printing” is displayed on Operation panel.
• Starts confirmation adjustment printing.
• When the Confirm Print is complete, the printer enters the Normal condition.
d. After the confirmation adjustment printing, the media is cut.
4.6.3 Cut media
6. Measure the distance between the two pluses in the confirmation adjustment print using a ruler.
Then, confirm that the distance matches the feeding length when printing.
a. If the distance does not match the feeding length, follow the procedure from Steps 1 to 5 to
readjust.
b. If the distance matches the feeding length, proceed to step 7.
No. Name
1
Feeding length
2
Media feed direction
To Next Page
Loading...
Need help?
General