RJ-900X series OPERATION MANUAL Troubleshooting
6-21
6. Draw the media to your side, and cut the torn part with a razor blade, etc.
7. Lift both end of the scroller, and manually rewind the roll media.
8. Remove a torn piece of paper if a paper dust or a piece of paper remained inside the printer.
9.
If errors requiring a restart occur, temporarily turn off the [Power] key, and then turn it on again.
3.2.1 Turning the power ON
No. Name
1
Razor blade
2
Roll media
No. Name
1
Roll media
2
Scroller
To Next Page
Loading...
Need help?
General