MX T406 - Page 21

21
Subject to modication
4. Select the notch (2) that gives a gap of between 3 and 5 cm to
the ground when you manually raise the parking stand.
■
3...5 cm
2
5. In this position, lift the stop to meet the locking pin (3).
■
3
6. Perform the same procedure for the other parking stand.
■
— Disconnect the hydraulics and the electrics. Loader with MACH
System:
- Unlock the housing of the MACH System by pressing the
safety latch on the left, then lift the handle.
■