18
DISARMING WHEN RETURNING
Disarming the System
1. Enter your premises through the Entry/Exit door. The keypad sounds a steady tone as a reminder to disarm the system
before the Entry Delay time expires.
2. Enter your User Code and press ENTER. The red ARMED light turns off, indicating that the system is disarmed. If the code
is invalid, the keypad beeps 4 times, signifying an error. Re-enter your valid code immediately. Note: Ten seconds before
the Entry Delay time expires, the keypad emits a pulsing warning tone.
Important: If after disarming you notice the red ARMED light is flashing and "ALARM" is displayed, an alarm occurred while
you were out. Proceed with caution
! If you suspect that an intruder may still be on the premises, leave immediately and call
authorities from a neighbor's telephone.
Silencing an Audible Alarm
1. Enter your User Code and press ENTER.
Note: The first time the keypad PIR senses your presence (just before disarming), the keypad siren turns off, allowing a 15
second window of time to disarm. After the system disarms, the LCD window continues to display "ALARM" followed by the
zone(s) violated.
2. To reset the display, note the zones violated, then press C.
Ambush (Optional) Ambush Code Type: PREFIX UNIQUE. My Ambush Code is ___________________
If an intruder forces you to disarm the system, enter your Ambush Code and press ENTER. Disarming with your Ambush Code
sends a silent notification to the central station that you are being forced to disarm. At the keypad, the system will appear to
disarm normally without any indication that a silent notification has been sent (the red ARMED light turns off and "SYSTEM
READY" displays). There are two types of Ambush Codes: (1) A two-digit prefix entered just before your normal User Code and
(2) A separate and unique User Code .
• Prefix example: If your User Code is 1234 and your Ambush Code is 99, press 991234U.
• Unique example: If your User Code is 1234 and your Ambush Code is 8899, press 8899U.
To Next Page
Loading...
Need help?
General
