2
The GEM-K1VPS is a "smart" user-friendly,
interactive menu-driven keypad with an integral
motion sensor, integral siren, and integral
speaker designed for your NAPCO control
panel. Its alphanumeric screen not only dis-
plays the status of your system, the speaker
also provides step-by-step instructions to guide
you through all operations.
To Arm the system, simply enter code and
press either the STAY button (if staying within
the premises) or the AWAY button (if leaving).
This booklet contains important information
about the operation of your system with this
GEM-K1VPS keypad. Read it carefully and
keep it handy for future reference. Check the
Glossary for an explanation of terms that may
be unfamiliar to you.
You'll probably find subjects mentioned in
this booklet that do not apply to your system.
Napco control panels have such a wide variety
of features that few security systems, if any, will
ever need them all. Your alarm professional
has chosen appropriate features for your
particular needs.
Regardless of how your system has been
configured, rest assured that it has been
carefully designed and engineered to the
highest industry standards. To assure optimum
safety and security, familiarize yourself with this
equipment. Periodically check its condition and
state of readiness by testing it at least once a
week in both the ac/battery and battery-only
modes (ask your alarm professional how to
make these tests).
INTRODUCTION
IMPORTANT - TEST YOUR SYSTEM WEEKLY
Test your sounding device and backup
battery
(These tests should only be performed on
weekends or at a time designated by your
alarm company.)
1. While disarmed, press R.
2. Answer NO (press Q) until “ACTIVATE
BELL TEST” appears in the window.
3. Press YES (P) to execute the test. The
alarm will sound for about two seconds.
• If the alarm does not sound, call for service.
• If the battery is low, “LOW BATTERY E02-00
SERVICE” will appear in the display indicating
a low battery condition. Allow 24 hours for
the battery to recharge. If the trouble
continues, call for service.
Test your central station communicator
(Activate Dialer Test programmed? YES NO)
1. Notify your Central Station of the impending
test.
2. While disarmed, enter your User Code and
press R.
3. Answer NO (press Q) until “ACTIVATE
DIALER TEST” appears in the window.
4. Press YES (P) to send a test code to the
central station.
• If the test is not successful, “COMM FAIL
E03-00 SERVICE” will display, indicating a
communication failure. Call for service.
Note: Any subsequent successful transmission
will clear a “Failure to Communicate” system
trouble.
Test the Keypad Integral PIR
NOTE: The Integral PIR is not active when
disarmed. To confirm that it is functioning cor-
rectly, follow the procedure outlined below:
1. Enter a User Program Code, press R.
2. Answer NO (press Q) until “ACTIVATE PIR
TEST Y/N” appears in the window.
3. Press YES (P) to execute the test. The
keypad sounder will turn on immediately, indi-
cating it senses your presence. Move away
from the keypad and remain motionless until
the keypad sounder silences. Three steps in
any direction should re-activate sounder. If the
sounder does not sound, call for service.
To Next Page
Loading...
Need help?
General
