NAPCO GEM-K1VPS - Programming System Date and Time; Setting System Date; Setting System Time

34
PROGRAMMING (OPTIONAL)
Enter the User Program Mode
1. Enter your User Code, then press R to enter the Keypad Menu Mode.
2. Answer NO (Q) until “ACTIVATE PROGRAM Y/N” is displayed, then press
YES
(P).
3. “ENTER USER CODE” will display, press NEXT (P) until the keypad displays
the “ENTER DATE” screen.
Programming the Date
1. At the "ENTER DATE" screen, simply punch in the correct date using the numeric
keypad buttons.
 For example, for July 29, 2009, enter: 07 29 09
2. Press U to save the Date.
Programming the Time
After entering in the Date, press NEXT (P) for the "ENTER TIME" screen.
1. At the "ENTER TIME" screen, simply punch in the correct time using the numeric
keypad buttons and if necessary, press any numeric button to change the AM
display to PM (or vice versa).
 For example, for 6:30 PM, enter: 06 30 (0 if necessary)
2. Press U to save the time.
Programming the system Date and Time.
The User Program Mode may also be used to set the system Date and Time which display on the keypad.
ACTIVATE
PROGRAM Y/N
ENTER DATE
00/00/00
ENTER DATE
07/29/00
ENTER TIME
(12:00A)
ENTER TIME
(06:30P)