8
ARMING AWAY: ARMING WHEN LEAVING
System Trouble
The words "SYSTEM TROUBLE" display in the LCD Window and alternate with a trouble code (for example, a low battery con-
dition displays "E02-00"; see page 41 for a list of trouble codes). Attempting to arm with a System Trouble causes the key-
pad to sound a 3-second tone and the window to display "CAN'T ARM SYSTEM, PRESS RESET KEY". If you cannot correct
the problem immediately, pressing C allows you to arm in this condition. Be sure to call for service as soon as possible.
Area Arming (Optional)
Some systems may be divided into smaller independent subsystems, or "areas". Note that in a system partitioned into
multiple areas, a particular keypad may only arm one or more areas while other areas remain disarmed.
Manager's Mode (Optional)
The Manager's Mode allows the user to arm / disarm other areas in a partitioned system. To arm/disarm a different area:
1. Press the numerical key representing the other area number.
2. Press G followed by U. The keypad will now provide status and control of that area.
3. Enter your User Code followed by Q to arm AWAY (or press
P to arm STAY).
4. Press G followed by the area number, then press
U to return to the home area.
NOTE: The number of the area viewed appears on the right side of LCD window.
Global Arming (Optional)
To arm all areas simultaneously, press 9, G and enter your code followed by
U.
To disarm all areas simultaneously, press 0, G and enter your code followed by
U.
• The User Code must be valid in all area(s).
• If any zone is not secured, the keypad will display "CAN’T ARM SYSTEM, AREA X IN TROUBLE" ("X" indicates the number
of the area in trouble). All faulted zones in the respective area(s) must be secured or bypassed.
To Next Page
Loading...
Need help?
General
