Napoleon Vector Series - Remote Control Functions

EN
W415-2036 / D / 08.05.21
13
transmitter layout
2.4.1 changing the batteries in the remote / battery holder (including switch)
3.0 remote control layout
Remote Control
Power
(ON/OFF)
Function
Adjustment
(Flame Height, Hot Air
Distribution Speed, and
LED Light Colour Change)
Cycle Through Functions
(Flame, Hot Air
Distribution, and Light
Functions)
Install the 3 ‘AAA’
batteries into the
remote control, as
shown, then press
the ON button. The
battery holder will
beep 4 times to
indicate that the
remote’s command is
accepted.
note:
Low battery alarm
Key Lock
Room
Temperature
Light
Flame ON
Blower
Transmission
CPI mode
Accent Lights
LED Lights
Hot Air Distribution*
*Where fitted and where connected to the appliance control board.