W415-2036 / D / 08.05.21
EN
20
maintenance
This appliance is factory equipped with ceramic glass. Use only replacement parts as supplied by the appliance
manufacturer. DO NOT SUBSTITUTE MATERIALS.
!
WARNING
Buff lightly with a clean dry soft cloth to remove accumulated dust or fi ngerprints. Clean both sides of the glass
after the fi rst 10 hours of operation with an ammonia-free glass cleaner.
Thereafter, clean as required. If the glass is not kept clean permanent discoloration and / or blemishes may
result. Contact you local authorized dealer / distributor for complete cleaning instructions.
Razor blades, steel wool, or other metallic objects must not be used on both surfaces of the glass. Doing so
can remove a thin layer of metal from the razor blades, steel wool, or other metallic objects that may then be
deposited onto the coating. This can result in a discoloured stain or scratch-like mark. More importantly, this can
scratch the glass surface, thereby reducing its strength.
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
Contact your local authorized dealer / distributor for complete cleaning instructions.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact you local authorized dealer / distributor for
replacement parts.
DO NOT SUBSTITUTE MATERIALS.
5.1A
Vinegar-based glass cleaners have demonstrated an ability to provide a clean, streak free glass surface.
note:
• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
Firebox Glass Door :
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliance
manufacturer.
6.1 care of glass
!
WARNING
Buff lightly with a clean dry soft cloth to remove accumulated dust or fi ngerprints. Clean both sides of the glass
after the fi rst 10 hours of operation with an ammonia-free glass cleaner.
Thereafter, clean as required. If the glass is not kept clean permanent discoloration and / or blemishes may
result. Contact you local authorized dealer / distributor for complete cleaning instructions.
Razor blades, steel wool, or other metallic objects must not be used on both surfaces of the glass. Doing so
can remove a thin layer of metal from the razor blades, steel wool, or other metallic objects that may then be
deposited onto the coating. This can result in a discoloured stain or scratch-like mark. More importantly, this can
scratch the glass surface, thereby reducing its strength.
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
Contact your local authorized dealer / distributor for complete cleaning instructions.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact you local authorized dealer / distributor for
replacement parts. DO NOT SUBSTITUTE MATERIALS.
5.1A
Vinegar-based glass cleaners have demonstrated an ability to provide a clean, streak free glass surface.
note:
• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
A. Unlatch the glass guard assembly and carefully slide
assembly all the way out, see “glass guard removal /
installation (LVX only)” section.
B. Use a duster or a cloth to clean the back and be-
tween the two front panes of glass.
C. Clean the intermediate glass pane.
D. To clean the inside surface of the firebox glass door,
completely remove the glass guard assembly, see
“glass guard removal / installation (LVX only)” sec-
tion. Remove the glass door, see “door removal”
section and follow the instructions below.
Glass Guard Assembly (LVX only) :
The GGA-1 includes two pieces of glass, one of which is floating. Take care never to lift the GGA-1 upside
down or the floating piece of glass can become detached and may break. Always handle the GGA-1 with the
mounting hooks pointing downwards. Should the floating piece of glass ever need to be removed (not recom-
mended for installation, maintenance and/or cleaning), the front side MUST be marked prior to removal. The
GGA-1 floating glass includes special glass coatings from the factory and the glass can only be installed one
way around. Always reassemble the floating glass piece in the same direction as it was removed or the
product performance will be compromised.
important:
4
Do not use ammonia-based cleaners.
To Next Page
Loading...
Need help?
General
