W415-2036 / D / 08.05.21
EN
32
maintenance
LV38-1 Illustrated
Ensure to leave one hand on the glass door during entire door removal.
Ensure the door opens freely and closes sealed.
note:
note:
IMPORTANT: Once latches are engaged, test to make sure that the door is sealed
A. For door removal, locate the top and bottom door latches. Pull forwards and away to disengage
door latches.
B. Tilt the top of the door forwards 90 degrees, then lift it up and out of the door latches.
C. Reverse these steps to re-install the door, ensure the top and bottom door latches are properly
engaged prior to releasing the door.
BACK - FIXED SIDE (SEE THRU ONLY)
See-thru models have one fixed door that does not need to be remove by the owner. The inside surface of the
firebox glass (fixed side) can be cleaned from the access side (see “care of glass” section).
The fixed side door operates as as a sealed system that is a critical component of your appliance’s operation.
This should only be removed by a qualified installer.
note:
6.6 firebox glass door removal
To Next Page
Loading...
