Name: Napoleon Vector Series
Brand: Napoleon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

W415-2036 / D / 08.05.21

maintenance

6.2 care of plated parts

6.1

If the appliance is equipped with plated parts, you must clean ﬁ ngerprints or other marks from the plated surfaces

before operating the appliance for the ﬁ rst time. Use an ammonia-free or vinegar-based cleaner and a towel

to clean. If not cleaned properly before operating for the ﬁ rst time, the marks can cause permanent blemishes

on the plating. After the plating is cured, the ﬁ ngerprints and oils will not affect the ﬁ nish and little maintenance

is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause

discolouration on plated parts.

The protective wrap on plated parts is best removed when the assembly is at room temperature but this can

be improved if the assembly is warmed (i.e. using a hair dryer or similar heat source).

note:

FOR SEE-THRU MODELS, REPEAT THE STEPS ABOVE ON THE FIXED SIDE. TO CLEAN THE INNER

SIDE OF THE GLASS DOOR ON THE FIXED SIDE, GO THROUGH THE ACCESS SIDE DOOR AND

CLEAN AS REQUIRED.

ﬁxed side

access side

(Illustration shows view from access side after access side ﬁrebox glass door removed.)

Other manuals for Napoleon Vector Series

Questions and Answers:

Need help?

Do you have a question about the Napoleon Vector Series and is the answer not in the manual?

General