Napoleon Vector TLV50N - Access Panel

EN
W415-4121 / B / 04.20.23
35
electrical information
6.6 access panel
Before fi nishing in the appliance, test the operation using the remote control, cycling it through all of its different
modes, see owner’s manual. Once fi nished in, access to the control components can only be done through the
inside of the appliance.
Pre-finishing access panel
!
WARNING
• Do not use this appliance if any part has been under water. Call a qualifi ed service technician immediately to
have the appliance inspected for damage to the electrical circuit.
• Risk of electrical shock or explosion. Do not wire 110V to the valve or to the appliance wall switch. Incorrect
wiring will damage controls.
• All wiring should be done by a qualifi ed electrician and shall be in compliance with local codes. In the
absence of local codes, use the current CSA22.1 Canadian Electric Code in Canada or the current National
Electric Code ANSI/NFPA NO. 70 in the United States.
• Always light the pilot whether for the fi rst time or if the gas supply has run out, with the glass door opened or
removed.
TLV50 Illustrated