Native Instruments Komplete Audio 6 - Page 42

KOMPLETEAUDIO6–Manual–41
ENGLISH
3. Plugthe1/4”TRSjackofyourheadphonesintothePHONESsocketontheKOM-
PLETEAUDIO6’sfrontpanel.TurntheVolumeControlknob(VOLUME)inthe
headphonesectionoftheKOMPLETEAUDIO6totheleft-endstoptosetthevolume
to minimum.
4. Opentheaudiopreferencesofyouraudiorecordingsoftware,andselectKOMPLETE
AUDIO6asyourinputandoutputdevice(youmayhavetorestartyourhostsoftware
forthechangestobecomeactive).Refertothedocumentationofyouraudiorecording
softwareforinformationonhowtoconguretheaudiodevicesetup.
5. Whilesinging/playinganinstrumentintothemicrophone,adjusttheinputsignalby
turningtherelevantinputchannel’sGAINknobgraduallytotheright.Checktheinput
LEDs(INPUT1and2onthetoppaneloftheKOMPLETEAUDIO6)tomakesureyour
inputsignaldoesnotclip;adjusttheinputlevelsothattheLEDslightgreenoninput.
A red lighting LED indicates signal clipping.
6. GraduallyturntheVolumeControlknob(VOLUME)intheheadphonesectionofthe
KOMPLETEAUDIO6totherightuntilyoureachagoodlisteninglevel.

Forinformationonhowtorecordinyouraudiorecordingsoftware,pleaserefertoyour
software’sdocumentation.