Native Instruments Komplete Audio 6 - Connecting Line Level Equipment

42–KOMPLETEAUDIO6–Manual
7.3.3 ConnectingaGuitar/BassGuitar(withheadphones)
7.5KOMPLETEAUDIO6setupwithguitar/bassguitarandheadphones.
MakesuretohaveconnectedtheKOMPLETEAUDIO6toyourcomputerasdescribedduring
theinstallationchapter(chapter3)ofthismanual.
TousetheKOMPLETEAUDIO6inarecordingsetupwithaguitar/bassguitar:
1. TurntheVolumeControlknob(MAINVOLUME1/2)onthetoppaneloftheKOMPLETE
AUDIO6totheleft-endstoptosetthevolumetominimum.
2. Pluga1/4”instrumentcable(unbalanced)fromyourinstrumentintoeitherINPUT1or
INPUT2oftheKOMPLETEAUDIO6.
3. MakesuretheLINE/INSTbuttonadjacenttothejackissettoINST(forinstruments
withactiveelectronics,setthistoLINE).