Native Instruments Komplete Audio 6 Instruction Manual

KOMPLETEAUDIO6–Manual–49
ENGLISH
7.5.2 ConnectingaSynthesizerviaDigitalI/O
MakesuretoconnecttheKOMPLETEAUDIO6toyourcomputerasdescribedduringthe
installationchapter(chapter3)ofthismanual.
TousetheKOMPLETEAUDIO6withasynthesizerwithdigitaloutput:
1. ConnecttheKOMPLETEAUDIO6’sRCA(phono)inputjack5/6tothedigitaloutputof
yoursynthesizer.
2. For Windows users:OpentheKOMPLETEAUDIO6’sControlPanelsoftware.In
theControlPanel,gototheAudio Settings page and set the Digital Sync Source to the
External S/PDIF 5|6setting.TheKOMPLETEAUDIO6checksforavailabilityofexternal
syncingsources.Ifthesynchronizationrequestfails,theinterfaceswitchesbackto
internalclockmode.Ifsynchronizationispossiblethetoppanel’sSPDIFSYNClights
orange(seealsochapter5.3).
3. ForMacOSXusers:GotoApplications > Utilities > Audio and MIDI Setup to open the
Audio and MIDI Setup utility. From the Clock sourcedrop-downmenuselectExternal
Clock (S/PDIF).TheKOMPLETEAUDIO6checksforavailabilityofexternalsyncing
sources.Ifthesynchronizationrequestfails,theinterfaceswitchesbacktointernal
clockmode.Ifsynchronizationispossiblethetoppanel’sSPDIFSYNClightsorange
(seealsochapter5.3).

Native Instruments Komplete Audio 6 Specifications

General

Audio Resolution	24-bit/192kHz
Power Supply	USB bus powered
Audio Interface Type	USB
Simultaneous I/O	6 x 6
Number of Preamps	2
A/D Resolution	24-bit/192kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Phantom Power	Yes
Digital Inputs	1 x Coax (S/PDIF)
Digital Outputs	1 x Coax (S/PDIF)
Headphone Output	1 x 1/4" TRS
Software Included	Komplete Elements
Outputs	4 x analog (2 x TRS, 2 x RCA)