Native Instruments Komplete Audio 6 - KOMPLETE AUDIO 6 In A Recording Setup; Connecting a Condenser Microphone

KOMPLETEAUDIO6–Manual–37
ENGLISH
1. Plugthe1/4”TRSjackofyourheadphonesintothePHONESsocketontheKOM-
PLETEAUDIO6’sfrontpanel.TurntheHeadphoneVolumeControlknob(VOLUME)of
theKOMPLETEAUDIO6totheleft-endstoptosetthevolumetominimum.
2. Starttheplaybackofanaudioleonyourcomputer.
3. GraduallyturntheHeadphoneVolumeControlknob(VOLUME)oftheKOMPLETE
AUDIO6totherightuntilyoureachagoodlisteninglevel.
7.3 KOMPLETEAUDIO6inaRecordingSetup
ThefollowinginstructionswillassistyouinusingtheKOMPLETEAUDIO6inarecording
situation for capturing audio to your computer, and monitoring the input and result over
yourspeakersorheadphones.Inmostcases,youwilluseathirdpartyDAW(digitalaudio
workstation)softwareor another audio recording and editingsoftware for recording voice
orinstruments.ForinstructionsonhowtocongureaudioandMIDIroutingandrecording,
pleaserefertoyoursoftware’sdocumentation.
7.3.1 ConnectingaCondenserMicrophone
7.3KOMPLETEAUDIO6setupwithmicrophoneandheadphones.
Make suretohaveconnectedtheKOMPLETEAUDIO6toyourcomputerasdescribedduring
theinstallationchapter(chapter3)ofthismanual.