Native Instruments Komplete Audio 6 - Connecting MIDI Devices

44–KOMPLETEAUDIO6–Manual
7.3.4 ConnectingLineLevelEquipment(Synthesizer/Computer/Tapedeck/
MixerLineOut)
7.6KOMPLETEAUDIO6setupwithasynthesizerandactivespeakers.
MakesuretheKOMPLETEAUDIO6isconnectedtoyourcomputerasdescribedduringthe
installationchapter(chapter3),andconguredasyourcomputer’smainaudiooutputdevice
(seechapter4).Seechapter7.1for instructionsonhowtoconnectspeakers(activeand
passive)toyourKOMPLETEAUDIO6.
TousetheKOMPLETEAUDIO6inasetupwithtypicallinelevelequipment:
1. TurntheVolumeControlknob(MAINVOLUME1/2)onthetoppaneloftheKOMPLETE
AUDIO6totheleft-endstoptosetthevolumetominimum.
2. Plugapairofstereo1/4”TRScablesfromtheoutputsofyourdeviceintotheinputs3
and4ontherearpaneloftheKOMPLETEAUDIO6.