Industrial Cellular VPN Router NR500 Series User Manual
Page 52 / 78
• Local Port
Sets the LAN port number range used when forwarding to the destination IP address.
• Enable
Check this box to enable DMZ function.
• Remote Address
Optionally restricts DMZ access to only the specified WAN IP address.
NOTE: If set to 0.0.0.0, the DMZ is open to all incoming WAN IP addresses.
• DMZ Host Address
The WAN IP address which has all ports exposed except ports defined in the Port Forwarding
configuration.
4.5.2 Route
Static Routing refers to a manual method of setting up routing between networks. Select the
Static Routing tab to add static routes to the Static Route Table.
Please refer current route table as below.
Route->Route Table Information
• Destination
Displays the destination of routing traffic.
• Netmask
Displays the subnet mask of this routing.
To Next Page
Loading...