NavigateWorx NR500 Series - Page 59

Industrial Cellular VPN Router NR500 Series User Manual
Page 58 / 78
VPN->OpenVPN
• Enable
Check this box to enable OpenVPN tunnel.
• Description
Enter a description for this OpenVPN tunnel.
• Mode
Select from “Client” or “P2P”.
• Protocol
Select from “UDP” or “TCP Client”.
• Connection Type
Select from “TUN”, “TAP” which are two different kinds of device interface for OpenVPN. The
difference between TUN and TAP device is that a TUN device is a point-to-point virtual device on
network while a TAP device is a virtual device on Ethernet.
• Server Address
Enter the IP address or domain of remote server.
• Server Port
Enter the negotiate port on OpenVPN server.