Industrial Cellular VPN Router NR500 Series User Manual
Page 59 / 78
• Authentication Method
Select from "X.509", "Pre-shared", "Password", and "X.509 And Password".
• Encryption Type
Select from "BF-CBC", "DE-CBC", "DES-EDE3-CBC", "AES-128-CBC", "AES-192-CBC" and "AES-256-CBC".
• Username
Enter the username for authentication when selection from “Password” or “X.509 And Password”.
• Password
Enter the password for authentication when selection from “Password” or “X.509 And Password”.
• Local IP Address
Enter the local virtual IP address when select “P2P” mode.
• Remote IP Address
Enter the remote virtual IP address when select “P2P” mode.
• Local Netmask
Enter the local netmask when select “TAP” connection type.
• TAP Bridge
Select the specified LAN that bridge with OpenVPN tunnel when select “TAP” connection type.
• Renegotiate Interval
Enter the renegotiate interval if connection is failed.
• Keepalive Interval
Enter the keepalive interval to check the tunnel is active or not.
• Keepalive Timeout
Enter the keepalive timeout, once connection is failed it will trigger the OpenVPN reconnect.
• Fragment
Enter the fragment size, 0 means disable.
• Private Key Password
Enter the private key password for authentication when selection from “X.509” or “X.509 And
Password”.
• Output Verbosity Level
Enter the level of the output log and values.
To Next Page
Loading...
Need help?
General