85
Your line group numbers are 1-9, 01-
99 or 001-200. Ask your Communications
Manager.
2. Dial number.
1. + .
The system automatically routes your
call using ARS or Trunk Group Routing
- whichever is installed.
Converting from Pulse to Tone Dialing
If your company is in a Dial Pulse area, you may need to change the
dialing mode of your phone to tone (DTMF) after you place your ini-
tial call. This allows you to use dial-up services like electronic bank-
ing or a client's Voice Mail.
1. Place outside call normally.
Your call dials out as Dial Pulse.
2. .
The next digits you dial go out as
DTMF.
Instead of dialing #, the system may
automatically convert to DTMF 10 sec-
onds after you dial the last digit of your
outside call.
Are You Behind a PBX?
Your telephone system may be connected to a Private Branch
Exchange (PBX) rather than to the telephone company's lines. This
means that when you get dial tone on an outside line, you are really
getting dial tone from the PBX. This may affect the way you place
outside calls. For example:
●
After you press a line key, you may have to dial an additional
access code (e.g., 9) before you can dial your outside number.
To change your dial-
ing mode to DTMF:
To use Trunk Group
Routing or ARS:
To dial a code to a
select line group
(Cont’d)
Outside Calls, Placing
0893400_04.qxd 8/11/04 10:42 AM Page 85
To Next Page
Loading...
Need help?
General
