EasyManuals Logo

NEC Aspire User Manual

NEC Aspire
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
Section 2: Components
Product Description 29
2
The 64-port basic CPU (P/N 0891002), with the basic factory-installed PAL chip, provides:
64 ports maximum for trunks, extensions, voice mail (internal or external), Aspire Wireless 2.4
GHz and IP Phones
With software 4.93+, if all 64 ports are required and IntraMail is not being used, set
Program 47-01-17 to “0” to make these ports available.
256 virtual extensions
Supports the 4VOIPU PCB and 4VOIPDB
Supports TAPI 1.x
VRS (Requires DSPDB Daughter Board and software 2.00+ - prior to this software version,
the VRS is not supported by the basic factory-installed PAL chip)
T1 Trunks (Requires software 4.0E+ - prior to this software version, this was not supported)
PRI Trunks (Requires software 4.0E+ - prior to this software version, this was not supported)
DSPDB Daughter Board (providing 32 channels for the DTMF Receiver, Call Progress Tone
Detection and Caller ID Receivers) (Requires software 4.0E+ - prior to this software version,
the DSPDB did not support the additional channels)
Supports the 32ESIU PCB
inDepth without ACD (Requires software 2.65+)
NOT SUPPORTED by the 64-port basic CPU, with the basic factory-installed PAL chip:
The 64-port basic CPU (P/N 0891002), with the Feature Upgrade PAL chip, provides:
128 ports maximum for trunks, extensions, voice mail (internal or external), Aspire Wireless
2.4 GHz and IP Phones
(Requires software 4.0E+ - prior to this software version, only 64 ports are supported)
256 virtual extensions
Supports the 4VOIPU PCB and 4VOIPDB
Supports TAPI 1.x
VRS (Requires DSPDB Daughter Board)
The 64-port basic CPU, with the Feature Upgrade PAL chip, supports:
Expansion Cabinet
Third-Party CTI/TAPI 2
16VOIPU PCB and
16VOIPDB
ACD
BRI S-Bus/T-Bus
E&M Trunks
Networking
Expansion Cabinet Third-Party CTI/TAPI 2 PRI Trunks
DSPDB Daughter Board (providing 32
channels for the DTMF Receiver, Call
Progress Tone Detection and Caller ID
Receivers)
16VOIPU PCB and
16VOIPDB
T1 Trunks
ACD/inDepth
BRI S-Bus/T-Bus
E&M Trunks
Networking
32ESIU PCB

Table of Contents

Other manuals for NEC Aspire

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Aspire and is the answer not in the manual?

NEC Aspire Specifications

General IconGeneral
VoIP SupportYes
Auto AttendantYes
Caller IDYes
Music on HoldYes
PagingYes
PowerAC adapter
DimensionsVaries by model
WeightVaries by model
NetworkingEthernet

Related product manuals