EasyManuals Logo

NEC Aspire User Manual

NEC Aspire
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
Section 2: Components
30 Product Description
The enhanced CPU (P/N 0891038) provides:
200 trunk ports maximum
512 extension ports maximum
- Aspire M/L: 256 analog/digital extensions,
- Aspire XL: 384 analog/digital extensions
- Aspire M/L or XL: NEC Wireless 2.4 GHz and IP Phones can have a maximum of 512 ports,
however, more than 256 (Aspire M/L) or 128 (Aspire XL) Wireless and IP phones reduces
the number of available extension ports.
256 virtual extensions
Supports the 4VOIPU PCB and 4VOIPDB
Supports TAPI 1.x
VRS (Requires DSPDB Daughter Board)
The enhanced CPU supports:
Each version of the NTCPU provides the following:
Five diagnostic LEDs which indicate the status of various system functions
During normal operation, the “RUN” LED will be ßashing and the remaining LEDs will be off.
1019x1019 Time Division Multiplex Switch (TDM Switch)
Digital Phase Locked Loop (DPLL)
Tone Generator
DTMF Tone Sender
32 Tone Resources (for DTMF Receiver, Caller ID Receiver, and Call Progress Tone Detection)
System Tone Sender
MFC Tone Sender
MF Signal Sender (Sends caller information to CO for E911)
Call Progress Tone Detector
C-Channel Control
Conference; 64 Channels
Caller ID Receiver; 32 Channels
Caller ID Sender; 4 or 10 Channels for Analog Stations
This can be expanded up to 20 by disabling 32 channels of the Conference circuits and
disabling the MFC Tone Sender.
A reset switch (RES) which can be used to reset the system
A load switch (LOAD) which is used for initial system startup or when upgrading
system software
One Serial Port
One USB Port (requires USB driver - download from NEC web site)
One Ethernet Port (10 Base-T/100 Base-TX)
One PCMCIA Slot
One EXIFU Interface Connector
Two Audio Input Terminals
Expansion Cabinet Third-Party CTI/TAPI 2 PRI Trunks
DSPDB Daughter Board (providing 32
channels for the DTMF Receiver, Call
Progress Tone Detection and Caller ID
Receivers)
16VOIPU PCB and
16VOIPDB
T1 Trunks
ACD/inDepth
BRI S-Bus/T-Bus
E&M Trunks
Networking
32ESIU PCB

Table of Contents

Other manuals for NEC Aspire

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Aspire and is the answer not in the manual?

NEC Aspire Specifications

General IconGeneral
VoIP SupportYes
Auto AttendantYes
Caller IDYes
Music on HoldYes
PagingYes
PowerAC adapter
DimensionsVaries by model
WeightVaries by model
NetworkingEthernet

Related product manuals